When the Samsung washing machine presents a U6 mistake, it means the drum runs out equilibrium during a cycle. It would certainly be more precise to say that there is no U6 error code amongst the Samsung codes (currently of creating this post!!!). This is a common Ub error code.
For some reason, numerous users perplex the b letter with 6. Some sites explain the error as “the water level sensor error”. Still, neither guidebooks, no the main site of the maker offers a summary of this mistake code.
Why does the U6 mistake happen?
As a rule, a modern Samsung cleaning equipment will attempt to balance the tons. If this does not function, it will forcibly quit the washing cycle and will certainly shut off. Or it will certainly present the U6 error code. Additionally, it may stop briefly turning and also display the U6 mistake. Anyhow, the clothes will certainly remain damp. The washer may revolve slowly if the load is fairly well balanced for low speed. Then if the discrepancy is still there, the washer will not quicken. So the laundry will be much wetter than it goes out after the common spin cycle.
The washer can not balance the washing tons in the drum, if:
The items are bunched up or have obtained tangled;
You have little loaded the washer: 1 or 2 items exist;
You overloaded the washer.
The error code generally shows up at the 9th, 7th or third min prior to the end of the washing cycle. Before the code is presented, the drum turns gradually for a few minutes in one and the other direction. It means the machine attempts to stabilize the laundry load. The timer is stopped briefly.
How to avoid the u6 error
The very first point to do about this error is to check if the cleaning machine is steady. Maybe throughout the previous washing as well as rotate cycles, the washing equipment relocated somewhat. So currently one of the legs impends.
A small void between the leg and the floor might boost the amplitude of drum vibrations at broadband
Just how to level the washing machine Samsung
Next, you require to examine the washing load in the cleaning equipment and the washing-spin mode:
The load | The reason for the error code to appear | Troubleshooting |
One or two items. | The washing machine can not rearrange the laundry evenly along the drum surface. The main load lies on only one section of the drum. | Load at least 3-4 items. |
One big (heavy) item and a few small (lightweight) laundry items. | Set the spin speed to 400 rpm or start the washing cycle without spin. | |
The loaded items are made of different fabrics. | Each type of fabric absorbs water differently. So the weight of the laundry items may differ, and the spin cycle won’t go properly. | Load the items made of similar fabrics. |
Bed linen. | During the washing cycle, the items get tangled or get in a duvet cover or a pillowcase. | Load no more than 2 kg of the linen at a time. Set the spin speed to 800 rpm. |
Overload. | If there is a lot of laundry in the washer, it is more difficult to spread it in the drum. | Only the “Cotton” mode allows the maximum load of the washing machine. See user manual to learn the right way to load the washer. |
How to Do Washing.
Nowadays you can acquire a Samsung cleaning machine with a large drum. The ordinary drum is presently for a 6 kg tons. However you can acquire a washing maker where you can fill 7, 8 or even 10 kg of washing. Maybe these washing machines are most likely to quit the spin if underloaded. Why? They call for much more things to make the tons.
In some cases unbalanced lots take place by chance: the washing machine spreads the weight in a strange disorderly way. Yet, it is possible to lower both the risk of inequality as well as the amplitude of resonances. Continuous unbalanced lots may trigger breakdowns of your cleaning machine.
If the above approaches don’t assist to stabilize the washing machine, then the most likely reason is a technological trouble. It may be the motor, the shaft of the drum, nuts, as well as gaskets.